Search

Monochrome analog - Monochrome progressive scan - Colour - 3 CCD colour

All cameras are supplied without lens, unless otherwise indicated

KP-M1AP(R1)
spectral response characteristics
Compact lightweight high resolution 2/3" camera.                                     New imager Eight-step electronic shutter function. Internal/external sync, interlace/non interlace capabilities. Restart and reset function. Frame and field integration modes. Resistant to vibrations. EIA version available: KP-M1AN(R1)
Imaging device	2/3" interline transfer CCD (8.8 x 6.6mm sensing area)
Pixels	756(H) x 581(V) effective
Cell area	11.0 (H) x 11.0 (V) µm
Scanning	CCIR 2: 1 interlace, non interlace (only with ext. sync.)
Syncronization	Internal/external (aautomatic switching
Sync signal input	Hd/Vd: 2 to 6Vp-p SYNC: 0.3Vp-p (VS or VBS possible) Input impedance: 1Kohm, negative polarity
Resolution at center	560(H), 575 (V)
S/N ratio	56 dB
Shutter speed	1/10000, 1/4000, 1/2000, 1/1000, 1/500, 1/250, 1/125, 1/100, OFF(normal exposure) Settings by external switch on rear panel settings of shutter speed
Illumination	standard: 400 lux (f4, 3200 °K) minimum: 0.5 lux f1.4 with AGC=ON, gamma=0.45 without IR cut filter
Video output	1Vp-p video composite, 75 ohm, connection diagram on the rear panel
Integration mode	Frame or field mode selectable by external switch (factory set: frame mode)
Reset restart	ON/Off selectable by internal switch (factory set value: OFF) input signal: 5Vp-p, 1Kohm
AGC	Normal gain/AGC (selectable by internal switch)
Gamma	0.45/1.0 (selectable by internal switch) (factory set value: 1.0)
Temperature and humidity	full specification: 0°C to 40°C, 50% to 70% RH operating: -10°C to 50°C, 90% or less RH storage: -20°C to 60°C, 70% or less RH
Lens mount	C
Resistance to vibrations	9G (10 to 55 Hz), 7G (11 to 200Hz)
Resistance to shock	70G
Power supply	12Vdc +-1V
Current consumption	approx. 210mA
Dimensions (W x H x L)	44mm x 29mm x 72mm dimensional drawing
Weight	120g
Rear panel

KP-M2AP/KP-M3AP
Compact lightweight high resolution 1/2" (KP-M2) and 1/3" (KP-M3) cameras. Eight-step electronic shutter function. Internal/external sync, interlace/non interlace capabilities. Field-on-demand function. Frame and field integration modes. Resistant to vibrations. EIA versions available: KP-M2AN/KP-M3U
	KP-M2	KP-M3AP
Imaging device	1/2" interline transfer CCD	1/3" interline transfer CCD
Total pixels	795(H) x 596(V)
Effective pixels	752(H) x 582(V)	752(H) x 585
Unit cell size	8.6 (H) x 8.3(V) µm	6.5(H) x 6.25(V) µm
Imaging area	6.47mm x 4.83mm	4.89mm x 3.64mm
Scanning	CCIR 2: 1 interlace, 625 lines fv=2fh /625
Lens mount	C
Horizontal scanning frequency	15.625 KHz
Vertical scanning frequency	50 Hz
Syncronization	Internal/external (automatically switchable)
External sync input	Hd/Vd: 2 to 6Vp-p, negative polarity Input impedance: 1Kohm frequency deviation: ± 1%
Number of horizontal lines allowable for external syncronization	2:1 interlace CCIR: 621 to 2047 lines/2FLD,1FLD (61 to 15Hz) non interlace CCIR: 310 to 1023 lines/1FLD, 1FLD (51 to 15Hz)
Video output	1Vp-p video composite, 75 ohm Video component: 0.7 Vp-p Sync component: 0.3 Vp-p (negative polarity)
Resolution	560(H), 575 (V)
Illumination	standard: 400 lux (f4, 3200 °K) minimum: 0.5 lux, f1.4 with AGC=ON, gamma=0.45 without IR filter
S/N ratio	56 dB
Electronic shutter	1/10000, 1/4000, 1/2000, 1/1000, 1/500, 1/250, 1/125, 1/120 sec  OFF: normal exposure selectable by external switch
Integration	Frame or field selectable by external switch
Gamma	1.0 or correction, selectable by internal switch
AGC	fixed gain/AGC selectable by internal switch
Field-on-demand function	ON/OFF selectable by internal switch
Reset/restart function	ON/OFF with chip component switch
Power supply	12Vdc ±1V
Temperature and relative humidity	full specification: 0°C to 40°C, 50% to 70% RH operating: -10°C to 60°C, 90% or less storage: -20°C to 60°C, 70% or less
Vibration resistance	9G max (10 to 60 Hz, amplitude: constant at 0.98mm), 7G constant (60 to 150 Hz, amplitude: variable) 10 to 150 Hz, sweeping for one minute for 30 min each of  X,Y,Z directions
Power consumption	@180 mA
Dimensions (W x H x D)	44mm x 29mm x 72mm dimensional drawing
Weight	120g
Standard composition	camera, C mount cap, operation manual

KP-M2RP
spectral response characteristics
Camera operating in the near infrared spectrum. Compact lightweight high resolution 1/2" camera. Eight-step electronic shutter function. Internal/external sync, interlace/non interlace capabilities. Field-on-demand function. Frame and field integration modes. Resistant to vibrations.
Imaging device	1/2" interline transfer CCD
Total pixels	795(H) x 596(V)
Effective pixels	752(H) x 582(V)
Unit cell size	8.6 (H) x 8.3(V) µm
Imaging area	6.47mm x 4.83mm
Scanning	CCIR 2: 1 interlace, 625 lines fv=2fh /625
Lens mount	C
Horizontal scanning frequency	15.625 KHz
Vertical scanning frequency	50 Hz
Syncronization	Internal/external (automatically switchable)
External sync input	Hd/Vd: 2 to 6Vp-p, negative polarity Input impedance: 1Kohm frequency deviation: ± 1%
Number of horizontal lines allowable for external syncronization	2:1 interlace CCIR: 621 to 2047 lines/2FLD,1FLD (61 to 15Hz) non interlace CCIR: 310 to 1023 lines/1FLD, 1FLD (51 to 15Hz)
Video output	1Vp-p video composite, 75 ohm Video component: 0.7 Vp-p Sync component: 0.3 Vp-p (negative polarity)
Resolution	560(H), 575 (V)
Illumination	standard: 30 lux (f4, 3200 °K) minimum: 0.3 lux, f1.4 with AGC=ON, gamma=ON
S/N ratio	56 dB
Electronic shutter	1/10000, 1/4000, 1/2000, 1/1000, 1/500, 1/250, 1/125, 1/120, 1/50 sec   OFF: normal exposure selectable by external switch factory setting: OFF
Integration	Frame or field selectable by external switch factory setting: frame
Gamma	1.0 or correction, selectable by internal switch factory setting: fixed
AGC	fixed gain/AGC selectable by internal switch factory setting: fixed gain
Field-on-demand function	ON/OFF selectable by internal switch factory setting: OFF
Reset/restart function	ON/OFF with chip component switch factory setting: OFF
Power supply	12Vdc ±1V
Temperature and relative humidity	operating: -10°C to 50°C, 90% or less storage: -20°C to 60°C, 70% or less
Vibration resistance	9G max (10 to 60 Hz, amplitude: constant at 0.98mm), 7G constant (60 to 200 Hz, amplitude: variable) 10 to 200 Hz, sweeping for one minute for 30 min each of  X,Y,Z directions
Power consumption	@180 mA
Dimensions (W x H x D)	44mm x 29mm x 72mm  dimensional drawing
Weight	120g
Standard composition	camera,  operation manual

KP-M2OP
1/2" (KP-M20) and 1/3" (KP-M30) ultra compact cameras with high resolution and high sensitivity. Hd/Vd input output. Electronic shutter
Imaging device	1/2" interline transfer CCD
Total pixels	795(H) x 596(V)
Effective pixels	752(H) x 582(V)
Horizontal scanning frequency	15.625 KHz
Vertical scanning frequency	50 Hz
Pixel clock	14.187 MHz
Video output	1Vp-p video composite, 75 ohm
Gamma	ON (0.45), OFF (1)
Shutter	1/50, 1/120, 1/250, 1/500, 1/1000, 1/2000, 1/4000, 1/10000 sec
Lens mount	C
Power consumption	@1.5W
Power supply	12Vdc ±1V
Dimensions (W x H x D)	29mm x 29mm x 38.5mm  dimensional drawing
Weight	55g
Pin configuration	pin configuration

Optional accessories	SG1201/JMH0110	12V power supply with connector
	JMH0110	12 pin connector
	TA-M1	Tripod adapter
	JU-M1A	Junction unit
	C-201KSM	2m cable
	C-501KSM	5m cable
	C-102KSM	10m cable

 

Reference technical notes
Introduction to CCD cameras

Cliccate sulle  parole evidenziate in giallo per vedere collegamenti a figure o ad altre pagine.
Click on words highlighted in yellow to view links.

Cliccate sulle immagini miniaturizzate per vederle ingrandite.
Click on thumbnails to view enlarged images.

Rapitron s.r.l.
NEW ADDRESS/NUOVO INDIRIZZO
  Via S.Antonio Maria Zaccaria 4  -  20122 Milano ITALIA
      Tel.: +39 02 659.82.82   Fax: +39 02 65.45.25

P.IVA/VAT No:  IT 04498890153

Queste pagine sono disegnate e aggiornate da Rapitron s.r.l.
I marchi citati sono di proprietà dei rispettivi proprietari.
Le specifiche dei prodotti sono esposte così come dichiarate dai singoli fabbricanti e sono soggette a cambiamenti senza preavviso.
Sito ospitato da Range s.a.s.- Genova

These pages are designed and updated esclusively by Rapitron s.r.l.
All trademarks are property of the respective owners.
All products specifications are shown as declared by manufacturers and are  subject to change without prior notice.
This Web Site is hosted by Range s.a.s. - Genova

Copyright ©2011 Rapitron s.r.l.
Last modified 25-10-2011